Operation instructions
C 950/C 1050 (Pro TL 175 C/199 C) – 6 720 805 440 (2019/10)
54
Saving water resources:
▶ Make sure you close all the taps after any use. Avoid leaving
the taps dripping. Repair any leaking tap.
▶ Define the temperature you want, in the appliance or with
the remote control. This way you have the precise water
flow needed (mixing cold water to regulate temperature will
increase the water flow with consequent waste of water).
The water heater will not ignite if inlet water temperature
exceeds the set point temperature less 9 °F (5 °C). In this
condition, the solar mode indicator will show on the LCD
display. See fig. 57, page 52.
Table 46
NOTICE:
Appliance damage!
▶ In applications where inlet water temperature can exceed
140°F (60ºC), a thermostatic or mixing valve must be
installed before the appliance to prevent water exceeding
140°F (60°C) from entering the appliance.
Fig. 62
6.5 Use of optional remote control accessory
(part no. 7709003213)
Fig. 63 Remote control
The wireless remote control accessory (fig. 87, component
13) and the temperature selector buttons on the front of the
water heater operate identically. Contact your distributor to
order the remote control accessory. Modification of the water
Solar mode activation
formula
Example:
Temp. inlet > Temp. set -
9°F (5°C)
104°F (40°C) > 112°F (44°C) -
9°F (5°C)
To Next Page
Loading...
