19 | english
August 2009 | C3 | Battery charger Automotive Aftermarket
Pulse charging
This is an automatic charger function which
cannot be selected manually. If the battery
voltage in 12 V mode is between 8 V (± 0.5 V)
and 10.5 V (± 0.5 V) at the start of charging,
the charger switches automatically to pulse
charging. On attaining a battery voltage above
10.5 V (± 0.5 V), the charger switches auto-
matically to the charging mode previously
selected. This enhances the charging process.
Appliance protection function
The charger switches to standby mode in the follow-
ing abnormal situations.
3 Battery voltage < 6 V (12 V batteries)
3 Open circuit
3 Reverse polarity
In the event of reverse polarity, the LED (9)
will also light up. If no other setting is made,
the system remains in standby mode.
Overheating protection
If the unit becomes excessively hot during charging,
the output power is automatically reduced to avoid
damaging the unit.
Always unplug the mains connector before work-
ing on the charger.
The unit is maintenance-free.
3 Switch off the unit.
3 Use a dry cloth to clean the plastic surfaces
of the unit.
3 Never use solvents or other aggressive
cleaning agents.
Maintenance and upkeep
Only for EC countries:
Never dispose of electrical
equipment together with
household refuse.
According the European Guideline 2002/96/EC
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
correct manner.
The packaging is made of ecological materials
which can be disposed of at local recycling facilities.
Disposal
To Next Page
Loading...
