Bosch C30 - Safety Precautions; General Safety Warnings; Explosion and Fire Hazards; Battery Compatibility

Bosch C30 charger I Operating instructions EN
14
2 Safety
Please read these instructions carefully before using the charger.
I
CAUTION
◾ If the power supply cable is damaged, it must be replaced by the manufacturer or
service representative in order to avoid any danger.
◾ Disconnect the power supply before making or breaking the connections to the bat-
tery.
◾ The battery connection, which is not connected to the vehicle body, must be
connected first (+) red. The other connection must be made to the vehicle body (–)
black, away from the battery and fuel lines. Only then connect the battery charger to
the mains supply.
◾ After charging, disconnect the battery charger from the mains supply first. Then
disconnect the connection to the vehicle body (–) black and battery connection (+)
red in this order.
I
WARNING
The mains plug must not come into contact with water. Water must be prevented from
flowing toward the mains supply to protect users from electrocution.
I
WARNING
Danger of explosion and fire!
Explosive gases.
◾ Prevent any flames or sparks.
◾ Provide adequate ventilation during the charging process.
◾ Ensure that the area around the battery is well ventilated during the charging
process.
Battery
Use the battery charger only for 12 V 1.2 Ah – 120 Ah or 6 V 1.2 Ah – 14 Ah lead acid
type (WET, EFB, GEL, AGM open and VRLA) batteries.
I
WARNING
Do not attempt to charge a non-rechargeable battery!