Bosch C30 charger I Operating instructions EN
16
3.4 Overheating protection
If the device becomes too hot during the charging process, the output power and out-
put current are automatically reduced to prevent damage to the device.
3.5 Standby and reverse polarity protection
Mode Indicator Explanation
Standby
Lights up during power on and in the event of faults
Reverse polarity protection
Lights up when the terminal clamps are reversed
4 Mode selection
1. Select the desired mode by pressing the mode selection button.
2. The LED for the desired mode will light up.
3. If no further action is subsequently taken, the charging process will start after 5 sec-
onds.
Mode Output
Indica-
tor
Operation Battery types supported
Mode 1
Car mode
14.4 V /
3.8 A
Press the button once to se-
lect mode 1
◾ LED 11 lights up
12 V lead acid, EFB, AGM
and most GEL batteries.
Capacity of > 14 Ah in
normal condition
Mode 2
12 V motorcycle
mode
14.4 V /
0.8 A
Press the button twice to se-
lect mode 2
◾ LED 10 lights up
12 V lead acid, EFB, AGM
and most GEL batteries.
Capacity of ≤14 Ah in
normal condition
Mode 3
Cold/AGM mode
14.7 V /
3.8 A
Press the button three times
to select mode 3
◾ LED 9 lights up
Cold state (0-4°C) of 12 V
lead acid, EFB and most
GEL batteries. And for
many 12 V AGM batteries
in normal condition. Ca-
pacity of > 14 Ah
Mode 4 regenera-
tion mode
1
16.5 V /
1.5 A
Press the button four times
to select mode 4,
◾ LED 8 & LED
11 will light up
Suitable for the regenera-
tion of 12 V batteries af-
ter short-term extreme
discharge. Capacity of >
14 Ah
Mode 5
6 V motorcycle
mode
7.2 V /
0.8 A
Press the mode button
to switch to mode 5
◾ LED 7 will light up
6 V lead acid, AGM, EFB,
and most GEL batteries.
Capacity of ≤14 Ah in
normal condition
To Next Page
Loading...
