en Faults and what to do about them.
24
Information on the display
panel
Faults and what to do about
them.
Display Cause/remedial action
YES The washing machine door is unlocked. It is possible to add laundry.
NO ■ Temperature too high. Wait until the temperature drops.
■ Water level too high. Not possible to add laundry. Close the washing machine
door immediately, if necessary. Select Start/Reload to continue the pro-
gramme.
NO flashes ■ Wait until YES lights up.
F:16 Close the door properly; laundry may become trapped.
F:17 ■ Turn the water tap on fully,
■ supply hose kinked or trapped,
■ water pressure too low. Clean the screen.
F:18 ■ Detergent solution pump blocked. Clean detergent solution pump.
■ The drain hose/waste pipe is blocked. Clean the drain hose on the siphon.
F:21 Motor fault. Call the after-sales service.
F:23 Water in the base tub, appliance leaking. Call the after-sales service.
E Childproof lock activated; deactivate it.
N flashes Too much foam detected, a rinse cycle has been switched on.
Faults Cause/remedial action
Water is leaking out. ■ Attach/replace the drainage hose correctly.
■ Tighten the screw connection of the supply hose.
No water supply.
Detergent not dispensed.
■ Start/Reload not selected?
■ Tap not turned on?
■ Filter blocked? Clean the screen. ~ Page 22
■ Supply hose kinked or trapped?
Washing machine door
cannot be opened.
■ Safety function active. Programme stopped? ~ Page 18
■ $ (without final spin) selected?
■ Can be opened by emergency release only? ~ Page 23
Programme does not
start.
■ Start/Reload or Finished in time selected?
■ Washing machine door closed?
■ E Childproof lock activated? Deactivate. ~ Page 17
Detergent solution is not
drained.
■ $ (without final spin) selected?
■ Clean detergent solution pump. ~ Page 21
■ Clean the waste pipe and/or drainage hose.
To Next Page
Loading...
Need help?
General