Bosch Climate 5000 Series - Page 12

12
|
User Manual
Bosch Climate 5000 Series Remote Control (06.2022)
3.4.3 SWING
Figure 12
1
1. Press the SWING button, and the horizontal louvers in the indoor unit will
oscillate up and down.
Figure 13
2. Press and hold the SWING button for more than 2 seconds and the vertical
louvers will oscillate horizontally.
Figure 14
3. Press the button again to stop the louvers in the current air fl ow direction.
Continue to press the SWING button until the desired airfl ow direction is
reached. There are 5 diff erent directions available.
Figure 15
3.4.4 ECO/GEAR
1. Gear mode lowers the maximum frequency of the compressor, reducing
energy usage. Press the ECO/GEAR button to access Gear mode through
the following sequence:
ECO --> GEAR 75% --> GEAR 50% --> Previous System Mode
This function is only available under COOL mode.
GEAR feature may not be available on all systems.
Figure 16
1
ECO operation: Under cooling mode, press this button, the remote controller
will adjust the temperature automatically to 24 C/75 F, fan speed of Auto to
save energy (only when the set temperature is less than 24 C/75 F). If the set
temperature is above 24 C/75 F, press the ECO button, the fan speed will change to
Auto, the set temperature will remain unchanged.
Pressing the ECO button, modifying the mode or adjusting the set
temperature to less than 24 C/75 F will stop ECO operation.
GEAR operation: Press the ECO/GEAR button to enter the GEAR operation as
following: 75%(up to 75% electrial energy consumption) --> 50%(up to 50%
electrial energy consumption) -->Previous setting mode. Under GEAR operation,
the display on the remote controller will alternate between electical energy
consumption and set temperature.