6
|
User Manual
Bosch Climate 5000 Series Remote Control (06.2022)
Operation of Buttons Continued
Figure 2
Button Description Function
FAN Button
Press this button to select the fan speed as follows:
AUTO --> SILENT (1%-20%) --> LOW (21%-40%) --> MED (41%-60%) --> HIGH (61%-100%)
Press the TEMP Up (
) or Down ( ) button to increase/decrease the fan speed in 1% increments.
NOTE: You can not switch the fan speed in AUTO or DRY mode
SWING Button
Press this button to activate/disable the horizontal louver auto SWING feature. The auto SWING feature will rotate
the louver up and down, blowing air into the room in a continuously moving up/down motion.
NOTE: Hold down for 2 seconds to activate the vertical louver auto swing feature.
ECO/GEAR Button
Press this button to enter the energy effi cient mode in the following sequence:
ECO --> GEAR(75%) --> GEAR(50%) --> Previous setting mode --> ECO
— While in COOL mode, press this button and the system will automatically be set to 24 °C/75 °F on
Auto fan speed to save energy (only when the set temperature is less than 24 °C/75 °F).
— If the set temperature is above 24 °C/75 °F, the fan speed will change to Auto, the set temperature
will remain unchanged
— Pressing the ECO button, changing the mode or adjusting the set temperature to less than
24 °C/75 °F will stop ECO operation.
TURBO Button
Press this button to Activate/Disable the TURBO function. TURBO function enables the unit to reach the preset
temperature at cooling or heating operation in the shortest time possible. The fan will run at a speed above HIGH.
LED Button
Press this button to Activate/Disable the indoor unit screen display. Press this button to light the display or clear
the display.
HUMIDITY Button
While in DRY mode, press this button to adjust the humidity setting between 35% and 85%. The humidity setting
will change in 5% increments. After setting the room humidity, it will display on the screen.
NOTE: Humidity level may not be able to adjust in all confi gurations.
Table 3
To Next Page
Loading...
