6 720 801 244 (2013/08)Compress 3000 DW FO
Operation Instructions | 31
Manual activation of the „Leg“ function
▶ Access the „Leg“ function and press „ok“.
Display with blinking indication „ “ active.
▶Press „ok“.
„Leg“ function activated.
Upon reaching a temperature of 60 °C for more than 35
minutes, the device returns to the previously selected mode.
5.6.5 „Set“ function - adjustments
The „Set“ function permits adjustment of the following values:
• Degrees Celsius or degrees Fahrenheit ( Section 5.9)
• Time and day of the week (Section 5.10)
Fig. 34 „Set“ function
5.6.6 „Purg“ function - purge
„Purg“ function is an auxiliary for the system purging process.
Fig. 35 „Purg“ function
To activate „Purg“ function
▶ Access „Purg“ function and press „OK“.Circulation pump
will start functioning and the timetable is displayed below
"Purg". After 5 minutes the appliance returns to the
operating mode previously selected.
5.6.7 „Info“ function - information
The „Info“ function permits display of the cumulative
consumption over the past 30 days.
Fig. 36 „Info“ function
Displaying the consumption
▶ Access the „Info“ function and press „ok“.
Displays cumulative consumption (in kWh).
„reset“ consumption
Display cumulative consumption.
Thermal disinfection requires about 6 to 7
hours additional time after normal heating
up. During most of this additional period the
disinfection is ensured by the electrical
element.
Therefore, it is recommended to be done
during a period of low energy tariffs
combined with low hot water demand to do
not compromise the energy savings.
To Next Page
Loading...
