6 | Failures / Errors
3 Failures / Errors
3.1 Elimination of errrors
All regulation, control and safety equipment of appliance is
controlled by the control unit.
B If any failure during operation occurs, symbol and
maybe will start to flash also. In additional the failure
code will be shown on display (e.g. EA).
B If and symbol on display flash:
B For the reset : Press and Stand by button until and
symbol expire on display.
The appliance will start up again and the flow temperature
will be displayed.
B If only symbol flashes:
B Switch the appliance first off and then on again by means
of the standby key.
The appliance will start up again and the flow temperature
will be displayed.
If a failure can not be eliminated :
B Contact your approved installer or Customer Service for
assistance, providing details of the fault and the appliance.
Danger: Explosion !
B Turn off gas cock before working on gas-
bearing components.
B Check for leaks before working on gasbear-
ing components.
Danger: Poisoning !
B Check for leaks before working on gasbear-
ing components.
Danger: Risk of electric shock !
B Always disconnect the power supply to the
appliance at the mains before carrying out
any work on the electrical systems and com-
ponents (fuse, circuit breaker).
Leaking water may damage the Cotronic mod-
ule.
B Cover the Cotronic module before working
on any parts that carry water.
For an overview of faults, see page 7.
To Next Page
Loading...
