en Troubleshooting
52
Fault Cause Troubleshooting
Tableware is not dry. Water collects in recesses of
the tableware or cutlery.
▶ Position tableware at an angle
where possible.
The combined detergent
used has a poor drying per-
formance.
1. Use rinse aid to improve drying per-
formance.
2. Use a different combined detergent
with a better drying performance.
Extra Dry not activated to im-
prove drying performance.
▶ Activate "Extra Dry" →Page39.
Tableware removed too
early or drying process not
yet ended.
1. Wait until the programme ends.
2. Only remove tableware 30minutes
after the programme has ended.
Rinse aid used has a limited
drying performance.
▶ Use a name-brand rinse aid.
Eco products may have limited ef-
fectiveness.
Appliance door does not
open automatically at the
end of the programme
▶ Adjust the appliance door as de-
scribed in the installation instruc-
tions.
The door gap must be at least
70mm - 100mm.
Plastic tableware is not dry. Not a fault. As plastic does
not store heat so well, it also
does not dry as well.
▶ No remedial action possible.
Cutlery is not dry. Cutlery not arranged prop-
erly in the cutlery basket or
cutlery drawer.
Droplets can form on the cutlery con-
tact points.
1. "Arrange cutlery individually where
possible." →Page36
2. Avoid points of contact.