Troubleshooting en
53
Fault Cause Troubleshooting
Appliance interior still wet
after wash cycle.
Not a fault. The condensa-
tion drying principle causes
water droplets in the tub –
they are indeed desirable
here. The moisture in the air
condenses on the inside
walls, runs off and is
pumped out.
No action required.
Remnants of food on table-
ware.
Tableware is placed too
close together or basket is
overfilled.
1. Arrange tableware with sufficient
space in between.
The spray jets must reach the sur-
faces of the tableware.
2. Avoid points of contact.
Spray arm rotation is
blocked.
▶ Arrange tableware so that it does
not obstruct spray arm rotation.
Spray arm nozzles are
blocked.
▶ Clean the "Spray arms" →Page46.
Filters are soiled. ▶ Clean the filters.
→"Cleaning filters", Page45
Filters are inserted incor-
rectly and/or not engaged.
1. Insert the filters properly.
→"Filter system", Page45
2. Engage the filters.
Washing programme selec-
ted too weak.
▶ Select a more intensive washing
programme.
→"Programmes", Page20
▶ Adjust the sensitivity of the sensors.
→"Sensors", Page13
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
▶ Only remove large remnants of food
and do not prerinse tableware.
▶ Adjust the sensitivity of the sensors.
→"Sensors", Page13
Tall narrow receptacles in
corner areas are not rinsed
adequately.
▶ Do not position tall narrow recept-
acles at too great an angle or in
corner areas.
Top baskets on right and left
are not set to same height.
▶ Set the top baskets on the left and
right to the same level.
To Next Page
Loading...
Need help?
General