ImportAppliances.com
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
60
en Simple troubleshooting
Problem Cause Solution
There is water under the
drip tray�
This water is condensed� Do not insert drip tray without
cover�
Display shows “12:00”
Power failure or appliance
switched o at mains.
Re-enter values; do not switch
the appliance o at the mains
or select the “off” option in the
Clock displ� menu�
Display shows
“Milk container
connected?”
despite connected milk
container�
Container is outside the range
of the sensor�
Position the container at the
right edge�
Material e�g� milk carton is not
recognised�
Conrm the display request
with “Yes” or use the enclosed
milk container�
Display shows
“Overvoltage or
undervoltage”
Voltage too high or too low� Contact electricity or grid pro-
vider� Have the power supply
checked by an expert�
Display shows
“Leave device to cool“
Appliance is too hot� Switch o appliance for
30 minutes�
Display shows, for
example:
“Fault: E0510”
The appliance has a fault� Proceed according to the
display screen�
Display shows
“Fill bean container”
although the container is
already full, or the grinder
is not grinding any beans�
Beans are not falling into the
grinding unit (beans too oily)�
Gently tap the bean container�
Possibly change the type of
coee. When the bean con-
tainer is empty, wipe it with a
dry cloth�
Display shows
“Clean brewing unit”
Brewing unit is soiled� Clean the brewing unit�
Too much ground coee in the
brewing unit�
Clean the brewing unit� Do
not place more than two level
measuring spoons of ground
coee in the drawer.
The mechanism of the
brewing unit is sti.
Clean the brewing unit, see
the section “Care and daily
cleaning”�
Display shows
“Refill with still water
or remove filter”
Water tank wrongly inserted Insert water tank correctly
Carbonated water in the water
tank�
Fill the water tank with fresh tap
water�
Float is stuck in the water
tank�
Remove the tank and clean
thoroughly�
New water lter not rinsed
according to instructions, or
water lter used or defective.
Rinse the water lter according to
the instructions and then switch
on, or use a new water lter.
Air in the water lter. Dip the water lter into water
until no more air bubbles
escape, replace the lter.