D1255TD Installation Instructions
© 2004 Bosch Security Systems Page 3 74-06859-000-D
D1255TD
3.0 Digital Keypad
The D1255TD Command Center features a digital keypad for accessing the menus, entering user passcodes and executing
system commands in the panel. As you press keys, the D1255TD emits a muted beep tone (Refer to section 6.0 Audible Tones,
p.4) to indicate that the entry has been accepted. The keypad lights when you press keys, and remains lit for 20 seconds.
When entering a passcode, press keys within 15 seconds of each other. If 15 seconds elapse between keystrokes, the entire
entry clears, and you must start over. The keypad also "times out" on other functions if you wait too long between key
presses.
4.0 Command Center Function Keys
The D1255TD has five function keys. These keys are used to control your system.
COMMAND Use the [COMMAND] bar in combination with one or two numeric keys to perform a function.
ENT/YES Key Use the [ENT(enter)/YES] key to complete the entry of your passcode at the command center.
The second function of the [ENT/YES] key is to select the menu item displayed.
PREV Key When viewing a list, pressing the [PREV] key will take you back to the previously shown item.
NEXT Key Press the [NEXT] key to pass over the present item in a menu or list.
MENU/ESC First, use the [MENU/ESC] key to show the command center functions that are programmed in the
Command Menu.
Second, use the [MENU/ESC] key to take you back to the idle display.
To Next Page
Loading...
