D1255TD Installation Instructions
© 2004 Bosch Security Systems Page 5 74-06859-000-D
D1255TD
7.0 DIP Switch Settings and Associated Functions
Located under the D1255TD Command Center cover (Figure 1), a six-position DIP Switch allows you to select the address
of each command center, and silence the keypad encoding tone.
To access the dipswitches, remove the front cover. Using a small flat-bladed screw-driver, gently push in the two bottom tabs
of the enclosure cover. As the tabs are pushed in, lift the cover away from the base.
7.1 Setting the DIP Switches
For supervised command centers, assign only one command center to each address.
Figure 1: D1255TD Internal Features
Table 3: Switch Settings
Switch
Address # 1 2 3 4 5 6
Address #1 ON ON ON ON ON
Address #2 OFF ON ON ON ON
Address #3 ON OFF ON ON ON
Address #4 OFF OFF ON ON ON
Address #5 ON ON OFF ON ON
Address #6 OFF ON OFF ON ON
Address #7 ON OFF OFF ON ON
Address #8 OFF OFF OFF ON
ENCODING TONE
ON/OFF
ON
To Next Page
Loading...
