23
Partially Turn On the Perimeter
❒ I have this feature.
❒ I do not have this feature.
❒ This feature requires a passcode.
This function is used to turn on the perimeter of your building while
selected portions of the perimeter remain turned off. Perimeter points that
are not secure (faulted) when this function is entered are not included in
the system. This function does not turn on the interior of your building.
Entry/exit delays are provided with this arming command.
Application
Use this function in residential systems to turn on the front of your house
while the interior and the rear perimeter doors are left turned off, giving
you freedom of movement between the house and patio.
In commercial systems, when you need access to the large overhead
doors to receive deliveries, using this function will allow you to keep the
rest of the building perimeter armed.
COMMAND 8
To arm with COMMAND 8:
1. Ensure that the command center is disarmed.
2. Decide which points are to be left disarmed. Fault the points (doors and
windows) by leaving them open. The point(s) must remain open until
after the exit delay time expires.
2. Press the COMMAND bar. The Command Mode indicator light comes
on.
3. Press the 8 key. The PERIMETER indicator light begins to flash. This
indicates that the system has begun exit delay time. When the exit
delay has expired, the PERIMETER indicator is continuously lit.
4. When performing a COMMAND 8, and no points are faulted, or the
points return to normal before the exit delay time expires, the system is
armed as in COMMAND 3.
5. To disarm your security system or cancel COMMAND 8, enter your
personal passcode then press ENT.
To Next Page
Loading...
