EN | 17
D9412G/D7412G | Operation & Installation Guide |
Bosch Security Systems | 10/03 | 43488E
3.0 Installation
3.1 Before Beginning
This section contains a general installation procedure
and refers to other sections of the document for detailed
instructions.
Bosch Security Systems recommends you review this
document and the D9412G/D7412G Program Entry Guide
before beginning the installation to determine the
hardware and wiring requirements for the features that
will be used.
Have the following documentation available when
reading through this guide:
• D9412G/D7412G Program Record Sheet
• Security System Owner’s Manual and Security System
Owner’s Manual Supplement
• Command Center Installation Manual (D1255,
D1256, D1257, D1260, or D720)
Before installation, become familiar with the operation
of the D5200 Programmer or the RPS.
3.2 Enclosure Options
Mount the control panel assembly in any of the Bosch
Security Systems enclosures listed:
• D8103 Universal Enclosure (tan)
• D8109 Fire Enclosure (red)
• D8108A Attack Resistant Enclosure (tan)
Refer to the D9412G/D7412G Approved Applications
Compliance Guide to determine if the application requires
a specific enclosure.
3.3 Beginning the Installation
1. Mount the enclosure in the desired location. Use all
five enclosure mounting holes (see Figure 2).
2. Run the necessary wiring throughout the premises
and pull the wires into the enclosure.
Electro-Magnetic Interference (EMI) may cause
problems. Refer to EMI on Long Wire Runs in the
D9412G/D7412G/D7212G Installation and Troubleshooting
Quick Reference Guide.
3.0 Installation
6 - Enclosure mounting hole (5)
7 - Mounting skirt hook hole (2)
8 - Back of D9412G/D7412G Control Panel
9 - Lock down tab
Figure 2: Enclosure Mounting
1
8
4
3
3
7
9
6
2 2
5
1 - Point chart label
2 - Mounting skirt hook (2)
3 - Module mounting hole (12)
4 - Tamper switch mounting hole (5)
5 - Skirt mounting hole (1)
To Next Page
Loading...
