Need help?Do you have a question about the Bosch FPA-1200 and is the answer not in the manual?
Measures for ensuring secure operation of service clients on PCs.
Warning about laser light from media converters.
Caution regarding internet access and secure IP connection for Remote Services.
Details on enabling various services like network over TCP/IP, OPC servers, etc.
Warning about unintentional data transfer via Ethernet interface.
Options for networking panels and remote keypads based on topology.
Explanation of RSTP protocol for ensuring loop-free networks.
Defining network diameter and factors to consider.
Compliance with EN 54 for network components.
Requirements for redundant panels regarding detection points.
Procedure for smaller projects with fewer engineers.
Procedure for larger projects with concurrent tasks by multiple teams.
How to connect CAN interfaces (CAN-H, CAN-L, CAN-GND).
Steps to create a CAN network using FSP-5000-RPS.
Diagram and explanation of panel networking over Ethernet.
Diagram and explanation of panel networking over CAN.
Description of Remote Connect for secure internet access to panels.
Security requirements for Remote Services via Private Secure Network.
Requirement to switch off IP networking for EN 54 compliance.
List of points to review before network installation.
Caution to only change DIP switch settings when de-energized.
Warning about laser light emitted by Ethernet switches.
Required settings for switches: IP address, redundancy, fault relay.
Steps to set network parameters in the switch interface.
EN54 compliance for BIS connection via OPC/FSI server.
Measures for ensuring secure operation of service clients on PCs.
Warning about laser light from media converters.
Caution regarding internet access and secure IP connection for Remote Services.
Details on enabling various services like network over TCP/IP, OPC servers, etc.
Warning about unintentional data transfer via Ethernet interface.
Options for networking panels and remote keypads based on topology.
Explanation of RSTP protocol for ensuring loop-free networks.
Defining network diameter and factors to consider.
Compliance with EN 54 for network components.
Requirements for redundant panels regarding detection points.
Procedure for smaller projects with fewer engineers.
Procedure for larger projects with concurrent tasks by multiple teams.
How to connect CAN interfaces (CAN-H, CAN-L, CAN-GND).
Steps to create a CAN network using FSP-5000-RPS.
Diagram and explanation of panel networking over Ethernet.
Diagram and explanation of panel networking over CAN.
Description of Remote Connect for secure internet access to panels.
Security requirements for Remote Services via Private Secure Network.
Requirement to switch off IP networking for EN 54 compliance.
List of points to review before network installation.
Caution to only change DIP switch settings when de-energized.
Warning about laser light emitted by Ethernet switches.
Required settings for switches: IP address, redundancy, fault relay.
Steps to set network parameters in the switch interface.
EN54 compliance for BIS connection via OPC/FSI server.
General| Model | FPA-1200 |
|---|---|
| Type | Fire Alarm Control Panel |
| Power Supply | 120 VAC, 60 Hz |
| Operating Temperature | 32°F to 120°F (0°C to 49°C) |
| NAC Outputs | 2 |
To Next Page