Bosch GAM 220 Professional - Display Elements; Technical Data; Assembly; Inserting;Replacing Batteries

14 | English
(15) Button MTR2 for compound mitre (GAM220MF)
(16)
Leg extension (GAM220MF)
(17)
Protective bag
Display Elements
(a) Indicator H for saved value Hold
(b)
Battery indicator
(c)
Measured value
(d) Bevel angle indicator BVL (GAM 220 MF)
(e) Mitre angle indicator MTR (GAM 220 MF)
(f) Corner angle indicator CNR (GAM 220 MF)
(g) Spring angle indicator SPR (GAM 220 MF)
Technical Data
Digital angle measuring
device
GAM 220 GAM 220 MF
Article number
3 601 K76 5.. 3 601 K76 6..
Hold function
● ●
Display illumination ● ●
"Simple mitre" operating
mode
– ●
"Compound mitre" operating
mode
– ●
Measuring range 0–220° 0–220°
Measuring accuracy of angles ±0.1° ±0.1°
Smallest display unit 0.1° 0.1°
Operating temperature –10°C to +50°C –10°C to +50°C
Storage temperature –20°C to +70°C –20°C to +70°C
Max. altitude 2000m 2000m
Relative air humidity max. 90% 90%
Pollution degree according to
IEC61010-1
2
A)
2
A)
Batteries 4×1.5V LR6(AA) 4×1.5V LR6(AA)
Rechargeable batteries 4×1.2V HR6(AA) 4×1.2V HR6(AA)
Operating lifetime (alkali-
manganese batteries) ap-
prox.
80 h 80 h
Automatic switch-off after
approx.
30 min 30 min
Leg length 400 mm 400 mm
Weight according to EPTA-
Procedure 01:2014
1.3 kg 1.2 kg
Dimensions (length× width×
height)
447 × 52 × 60 mm 447 × 52 × 60 mm
IP 54 (dust and splash-proof) ● ●
A) Only non-conductive deposits occur, whereby occasional temporary conductivity
caused by condensation is expected.
The serial number(10) on the type plate is used to clearly identify your measuring tool.
Assembly
Inserting/Replacing Batteries (seefigureA)
It is recommended that you use alkaline manganese batteries to operate the
measuring tool.
To open the battery compartment cover(5), press the locking mechan-
ism(6) and fold the battery compartment cover up. Insert the batteries/re-
chargeable batteries.
When doing so, ensure that the polarity is correct and corresponds to the
diagram on the battery compartment cover.
Battery Indicator
The battery indicator(b) always indicates the current battery status:
Indicator Capacity
90–100 %
60–90 %
30–60 %
10–30 %
0–10 %
The empty battery indicator flashes. You can measure for ap-
proximately another 15–20min from when the flashing begins
until the tool shuts down.
Always replace all the batteries at the same time. Only use batteries from the
same manufacturer and which have the same capacity.
1 609 92A 58K | (18.11.2019) Bosch Power Tools