Bosch GAM 220 Professional - Simple Mitre Operating Mode

16 | English
The measured value of the anglew between the base leg and fold-out leg is
indicated in the display. The required anglev between the base leg and leg
extension is calculated as follows:
v=180° – w
v
w
v
GAM 220 MF: "Simple Mitre" Operating Mode
The "Simple mitre" measurement is used to calculate the cutting angle MTR
when two workpieces with the same mitre have to form any outer angle x°
smaller than 180° (e.g. for skirting boards, banister columns or picture
frames).
The "simple mitre" operating mode is activated by pressing the but-
tonMTR1(14). The displayed value is always used for the calculation of the
MTR. If a saved value is being displayed (indicator(a) flashes), the calcula-
tion will be performed with the saved value regardless of the position of the
legs.
x°
When workpieces are to be fitted into a corner (e.g. for skirting boards),
measure the corner angle x° by positioning the fold-out leg and the base leg.
For given angles (e.g. picture frames), open the fold-out leg and the base leg
until the required angle is indicated in the display.
x°
x°
MTR
MTR
The mitre angle MTR, by which the two workpieces are to be shortened, is
calculated. For these mitre/bevel cuts, the saw blade is perpendicular to the
workpiece (the bevel angle is 0°).
MTR
Press the buttonMTR1(14). The calculated horizontal mitre angleMTR,
which has to be set on the chop and mitre saw, and the indicatorMTR will be
shown on the display.
1 609 92A 58K | (18.11.2019) Bosch Power Tools