9
Technical Data
Intended Use
The anglefinder/digital level is intended for measuring
and transferring angles and for calculating simple and
compound miter angles, checking and aligning horizon-
tals and verticals. It is suitable for indoor and outdoor
use.
Angle finder/Digital level GAM 270 MFL
Article number 3 601 K76 410
“HOLD” function ●
“Simple Miter” Operating Mode ●
“Compound Miter” Operating Mode ●
“Grade Measurement” Operating Mode ●
Display Illumination ●
Calibration ●
Measuring range 0°...270°
Measuring accuracy angle ±0.1°
Lowest indication unit 0.1°
Operating temperature 14 °F...122 °F
(–10 °C...+50 °C)
Storage temperature -4 °F...158 °F
(–20 °C...+70 °C)
Alkaline Batteries 4 x1.5V LR6 (AA)
Operating time approx.
1
50 h
Automatic switch-off after approx. 30 min
Leg length 23.6 in (600 mm)
Weight according to EPTA-Procedure
01/2003
3.3 lbs (1.5 kg)
Measuring range of grade measuring device
– 0°/90°
– 1°–89°
±0.05°
±0.1°
Working range of laser
2
100 ft (30 m)
Vertical levelling accuracy of laser ±0.5 mm/m
Horizontal levelling accuracy of laser ±1 mm/m
Clearance of laser exit – bottom edge of
anglefinder/digital level
1.2 in (30 mm)
Laser class 2
Laser type 650 nm, < 1 mW
Laser beam diameter (at 25 °C) approx.
– at 5 m distance
– at 10 m distance
0.1 in (3 mm)
0.3 in (8 mm)
Relative air humidity, max. 90 %
Dimensions
(length x width x height)
26.9 x 2 x 2.4 in
(684 x 52 x 60 mm)
IP 54 (dust and splash proof) ●
1)
Operating duration without laser
2)
The working range can be decreased by unfavorable
environmental conditions (e.g. direct sun irradiation).
The anglefinder/digital level can be clearly identified
with the serial number 13 on the type plate.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
