Bosch GCM 10 PROFESSIONAL - Function; Intended Use; Noise;Vibration Information; Wear Ear Protection!

English–51 609 929 E91 • (04.10) PS
3 FUNCTION
While reading the operating instruc
tions, refer to the corresponding illus
trations of the electrotool on the front
pages.
Intended Use
The electrotool is intended as a stationary machine for
making straight lengthways and crossways cuts in
wood. Horizontal miter angles of 48° to +48° as well
as vertical bevel angles of 0° to +45° are possible.
Noise/Vibration Information
Measured values are determined according to stan
dard EN 61 029 procedures.
The Aweighted noise levels of the tool are typically:
Sound pressure level: 97 dB(A)
Sound power level: 110 dB(A)
Measurement uncertainty K = 3 dB
Wear ear protection!
The handarm vibration is typically below 2.5 m/s
2
.
Product Specifications
Values apply for the rated voltage [U] of 230/240 V. For
lower voltages and models for specific countries,
these values can vary.
Switchon actions cause brief drops in the mains volt
age. For unfavourable mains conditions, interference
with other equipment can occur.
For mains impedance of less than 0.15 Ω, no interfer
ence can be expected.
For maximum work piece dimensions,
see the Working Instructions Section
Compound Mitre Saw GCM 10
PROFESSIONAL
Order number
0 601 B20 …
… 003
… 008
… 032
… 042
…004 … 005 … 006 …014 … 034
Rated input power [W] 1 800 1 800 1 650 1 800 1 650 1 650
Voltage [V] 230 220/230 115 230/240 220 120
Frequency [Hz] 50 50/60 50/60 50/60 50/60 60
No load speed [min
1
] 4 500 4 500 4 500 4 500 4 900 4 500
Tool spindle [mm] 30 25.4 25.4 25.4 30 16
Weight without mains cable [kg] 16.0 16.0 16.0 16.0 16.0 16.0
Saw blade ∅ [Inch] 10 10 10 10 10 10
Protection class / II / II / II / II / II / II
Compound Mitre Saw GCM 10
PROFESSIONAL
Order number
0 601 B20 …
… 037 …040 … 041 … 043 …050
Rated input power [W] 1 800 1 800 1 650 1 800 1 800
Voltage [V] 240 220 110 220/230 220/230
Frequency [Hz] 50 60 50 50 50/60
No load speed [min
1
] 4 500 4 500 4 500 4 500 4 500
Tool spindle [mm] 25.4 25.4 30 25.4 25.4
Weight without mains cable [kg] 16.0 16.0 16.0 16.0 16.0
Saw blade ∅ [Inch] 10 10 10 10 10
Protection class / II / II / II / II / II