To Next PageTo Next Page
Need help?Do you have a question about the Bosch GCM 10 PROFESSIONAL and is the answer not in the manual?
Keep work area clean, well-lit, and free of distractions for accident prevention.
Ensure correct voltage, avoid grounded surfaces, and protect from rain/wet conditions.
Stay alert, dress properly, avoid accidental starting, maintain balance.
Use clamps, don't force tool, disconnect plug before adjustments, maintain tools.
Tool repair must be performed by qualified personnel using identical replacement parts.
Explains machine-specific symbols for safety and operation.
Stationary machine for straight lengthways and crossways cuts in wood.
Details typical A-weighted noise levels and hand-arm vibration.
Recommends wearing ear protection due to typical noise levels.
Instructions for safe transport and handling of the machine.
How to secure the machine for transport using locking mechanisms.
Steps to release the machine from transport position to working position.
Instructions for installing the locking knob for miter angle adjustment.
Safety precautions and steps for changing the saw blade.
Detailed steps for safely removing the saw blade.
Instructions for correctly installing a new saw blade, including tooth direction.
Guidance on how to mount the tool securely to a workbench.
Describes how to attach the electrotool to a working surface using mounting holes.
How to clamp the electrotool to the working surface using screw clamps.
Importance of dust extraction and necessary protective measures.
How to attach and use the dust bag for chip extraction.
How to connect a vacuum cleaner for effective dust extraction.
How to reposition or extend the fence for different cutting operations.
Instructions for extending the saw table to support longer work pieces.
Steps to pull out and secure the saw table extension.
How to use the extension hoop for sawing equal length work pieces.
Proper methods for securely clamping the workpiece to ensure safety.
How to check and adjust the miter angle for precise cuts.
How to set common horizontal miter angles using detents.
How to set horizontal miter angles within the full range using fine scale.
Using the fine scale for accurate miter angle settings up to ¼°.
How to set common vertical bevel angles using provided stops.
How to set vertical bevel angles within the full range using the angle indicator.
Instructions for turning the tool on and off safely.
Detailed steps for operating the on/off switch and locking lever.
Basic rules for safe sawing, ensuring blade clearance and avoiding overload.
Correct hand and arm placement during operation for safety.
Table showing maximum dimensions for work pieces based on sawing angles.
Steps for performing straight crosscuts on work pieces.
Precautions for sawing curved or round work pieces and special fixtures.
How to replace a worn table insert for proper blade clearance.
Methods for cutting floor and ceiling moldings.
Keeping the machine clean, ensuring guard function, and general upkeep.
List of available Bosch accessories for the tool.
Guidelines for environmentally friendly recycling of the tool and packaging.
General