Bosch GCM 12 GDL Professional - Starting Operation and Working Advice; Starting Operation (Switching On;Off); General Sawing Instructions

42 | English
1 609 929 W31 | (6.4.11) Bosch Power Tools
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Ceiling Strips/Mouldings (According to US Standard)
Settings Placed
against the
fence
Lying flat on
the saw table
Floor strip/moulding
Left side Right side Left side Right side
Inner corner Horizontal mitre angle
45° left 45° right 0° 0°
Bevel angle
0° 0° 45° left 45° right
Positioning of work-
piece
Bottom edge on
saw table
Bottom edge on
saw table
Upper edge against
the fence
Upper edge against
the fence
The finished work-
piece is located...
... to the left of
the cut
... to the right of
the cut
... to the left of
the cut
... to the right of
the cut
Outer corner Horizontal mitre angle
45° right 45° left 0° 0°
Bevel angle
0° 0° 45° right 45° left
Positioning of work-
piece
Bottom edge on
saw table
Bottom edge on
saw table
Upper edge against
the fence
Upper edge against
the fence
The finished work-
piece is located...
... to the right of
the cut
... to the left of
the cut
... to the left of
the cut
... to the right of
the cut
To cut ceiling strips/mouldings facing flat on the saw table, the mitre angle must be set to 31.6° (saw
table must be turned left or right) and the bevel angle must be set to 33.9° (glide arm tilted left or right).
The following table includes information on sawing ceiling strips/mouldings.
Settings Placed
against the
fence
Lying flat on
the saw table
Ceiling strip/moulding
Left side Right side Left side Right side
Inner corner Horizontal mitre angle
45° right 45° left 31.6° right 31.6° left
Bevel angle
0° 0° 33,9° left 33,9° right
Positioning of work-
piece
Bottom edge
against the fence
Bottom edge
against the fence
Upper edge against
the fence
Upper edge against
the fence
The finished work-
piece is located...
... to the right of
the cut
... to the left of
the cut
... to the left of
the cut
... to the right of
the cut
Outer corner Horizontal mitre angle
45° left 45° right 31.6° left 31.6° right
Bevel angle
0° 0° 33,9° right 33,9° left
Positioning of work-
piece
Bottom edge
against the fence
Bottom edge
against the fence
Upper edge against
the fence
Upper edge against
the fence
The finished work-
piece is located...
... to the right of
the cut
... to the left of
the cut
... to the left of
the cut
... to the right of
the cut
52°
38°
52°
OBJ_BUCH-1360-001.book Page 42 Wednesday, April 6, 2011 11:11 AM