Fig.
23
Cutting line guides
The 0° cutting line guide 28 indicates the
position of the saw blade for straight
cuts whether or not a track is used.
When a track is used, it indicates the
position of the blade at any bevel angle.
The 45° line guide 29 indicates the
position of the saw blade for 45° bevel
cuts when not using the track (Fig. 23).
• The farthest-back point of a full-depth
plunge cut is indicated by the cast-in
cut limit mark 36 (Fig. 23).
• The farthest-forward point of a full-
depth plunge cut is indicated by the
red front cut limit mark 35 on the
clear plastic window (Fig. 23).
Dust/Chip Management
The saw’s dust port 18 swivels, allowing
the dust to exit in the desired direction.
DUST EXTRACTION
The dust port 18 will also accept the
typical rubber-like nozzles from 35 mm
vacuum cleaner hoses, such as the
VX120 that is included with the Bosch
VF-Series hoses.
To connect the saw to a 1-1/4” or 1-1/2”
hose, the Bosch VAC024 adapter (sold
separately) can be used.
Connect the other end of the hose to a
suitable dust extractor.
The dust extractor or vacuum cleaner
must be suitable for the type of dust that
will be created by sawing the workpiece.
To Next Page
Loading...
