English | 29
Bosch Power Tools 2 609 141 206 | (14.8.14)
Deleting the Memory
To delete the contents of the memory, press button 4 [Func] so that symbol ap-
pears on the display. Then briefly press the On/Off button 5 [ ] to delete the dis-
played value.
If the measuring tool is switched off during the memory function, the memory value
shown on the display will be deleted.
Adding/Subtracting Values
Measured values or end results can be added or subtracted.
Adding Values
The following example describes the addition of areas:
Measure an area as described in section “Area Measurement”, see page 27.
Press button 6 [+]. The calculated area is shown on the display, and
symbol “+” flashes.
Press the measuring button 2 [ ] to start another area measure-
ment. Measure the area as described in section “Area Measure-
ment”, see page 27.
Press button 6 [+] to calculate the sum. The end result is shown at
the bottom of the display.
To exit addition, press button 4 [Func].
Subtracting Values
To subtract values, press button 3 [–]. The subsequent steps are the same as for
“Adding Values”.
Changing the Unit of Measure
Unit of measure “m” (metres) is set by default.
Switch the measuring tool on.
OBJ_BUCH-2264-001.book Page 29 Thursday, August 14, 2014 4:14 PM
To Next Page
Loading...
