-17-
Laser detector power off, Level laser,
Spin mode
4. Locate the laser beam, using the red
sensor panel on the RCR1. As the laser
beam is approached, a single arrow points
in the direction of the beam. The base unit
emits sounds to aid in locating the laser
beam:
• Rapid beep - Indicates that the laser
detector is pointed overly high or far to
the left or right.
• Continuous tone - Indicates that the
laser detector is pointed directly toward
the laser beam.
5. Center the beam by moving the laser
detector in the direction of the arrow.
When the beam is aligned with the center
of the detector panel, both arrows on the
LCD display are lit and the beep is
continuous, indicating that it is properly
centered.
Note: Laser detector orientation depends on
whether it is being used to locate the level or
plumb laser beam.
6. To turn off the RCR1, press its power
On/Off button. There is a double beep for
confirmation, the LCD display becomes
blank, and the lasers shut off.
Charge-control Indicator
When the symbol for the battery indication 37
is indicated on the display 17, the laser
receiver can still be operated for approx. 4
hours.
To Next Page
Loading...
Need help?
General
