16
page headingMaintenance
Service
NO USER SERVICEABLE
PARTS INSIDE. Preventive
maintenance performed by un au thorized per-
sonnel may result in misplacing of internal
wires and components which could cause seri-
ous hazard. We recom mend that all tool service
be performed by a Bosch Factory Service Center
or Authorized Bosch Service Station.
Batteries
Be alert for battery packs that are nearing their
end of life. If you notice decreased tool perfor-
mance or significantly shorter running time be-
tween charges then it is time to replace the bat-
tery pack. Failure to do so can cause the tool to
operate improperly or damage the charger.
Tool Lubrication
Your Bosch tool has been properly lubricated
and is ready for use.
Motors
The motor in your tool has been engineered for
many hours of dependable service. To maintain
peak efficiency of the motor, we recommend it
be examined every six months. Only a genuine
Bosch replacement motor specially designed for
your tool should be used.
Cleaning
Certain cleaning agents and
solvents damage plastic
parts. Some of these are: gasoline, carbon tetra-
chloride, chlorinated cleaning solvents, ammo-
nia and household detergents that contain am-
monia.
Ventilation openings and switch levers must be
kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects
through opening.
Accessory Storage &
Maintenance
Store accessories in a cool dry place and avoid
freezing. Before use check accessory for cracks
and fractures, do not use if damage is suspected.
To avoid accidents, always disconnect the battery pack from tool before ser-
vicing or cleaning.
Accessories
Do not use attachments/accessories other than those specified by Bosch. Use
of attachments/accessories not specified for use with the tool described in this
manual may result in damage to tool, property damage, and or personal injury.
Standard equipment Optional accessories and attachments
– 1/3 Sheet Base Plate and Backing Pad 3.2” x 5.1”
– 1/4 Sheet Base Plate and Backing Pad 3.9” x 4.9”
– Detail Sheet Base Plate and Backing Pad 3.9 x 5.9”
– Dust Bag Assembly
– Sand Paper
– Hole Punch
– Additional Types of Sanding Sheets
– Vacuum Hoses
– Vacuum Hose Adapters
160992A72B GSS12V-40 202209.indd 16 8/31/22 11:33 AM
To Next Page
Loading...
Need help?
General
