5
page headingAdditional Safety Warnings
GFCI and personal protection devices like elec-
trician’s rubber gloves and footwear will further
enhance your personal safety.
Develop a periodic maintenance schedule for
your tool. When cleaning a tool be careful not
to disassemble any portion of the tool since
internal wires may be misplaced or pinched or
safety guard return springs may be improperly
mounted. Certain cleaning agents such as gaso-
line, carbon tetrachloride, ammonia, etc. may
damage plastic parts.
Some dust created by power
sanding, sawing, grinding,
drilling, and other construction activities con-
tains chemicals known to cause cancer, birth
defects or other reproductive harm. Some ex-
amples of these chemicals are:
• Leadfromlead-basedpaints,
• Crystalline silica from bricks and cement
and other masonry products, and
• Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies, depend-
ing on how often you do this type of work. To
reduce your exposure to these chemicals: work
in a well ventilated area, and work with ap-
proved safety equipment, such as those dust
masks that are specially designed to filter out
microscopic particles.
The power tool is intended for dry sanding of wood, plastic, filler and coated surfaces.
Intended Use
Battery Packs / Chargers:
Please refer to the battery/charger list, included with your tool.
NOTE: For tool specifications refer to the nameplate on your tool.
Model Number GSS12V-40
Voltage rating 12 V
No load speed 6,000-10,000/min
Permitted battery temperature during charging +32…+113°F (0…+45°C)
Permitted ambient temperature during operation and storage -4…+122°F (-20…+50°C)
Recommended ambient temperature during charging +32…+95°F (0...+35°C)
Weight 1.8 lbs.
Specifications
SAVE THESE INSTRUCTIONS
160992A72B GSS12V-40 202209.indd 5 8/31/22 11:32 AM
To Next Page
Loading...
Need help?
General
