English | 9
Bosch Power Tools 1 609 929 N43 | (24.4.08)
Technical Data
Assembly
f Before any work on the power tool itself,
pull the mains plug.
Replacing/Inserting the Saw Blade
f When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
Selecting a Saw Blade
An overview of recommended saw blades can be
found at the end of these instructions. Use only
T-shank saw blades. The saw blade should not be
longer than required for the intended cut.
Use a thin saw blade for narrow curve cuts.
Jigsaw GST 85 PB
Professional
GST 85 PBE
Professional
Article number
0 601 587 1.. 0 601 587 6..
Stroke rate control
– z
Rated power input
W580580
Output power
W350350
Stroke rate at no load n
0
spm 3100 500–3100
Stroke
mm 26 26
Cutting capacity, max.
– in wood
– in aluminum
– in non-alloy steel
mm
mm
mm
85
20
10
85
20
10
Bevel cuts (left/right), max.
°4545
Weight according to EPTA-Procedure 01/2003
kg 2.4 2.4
Protection class
/II /II
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltages and models for specific countries,
these values can vary.
Please observe the article number on the type plate of your power tool. The trade names of individual tools may vary.
OBJ_BUCH-689-001.book Page 9 Thursday, April 24, 2008 3:03 PM
To Next Page
Loading...
