Pipe Cover Installation Manual | BTC 710003301C | 06.2011 Technical specifi cations are subject to change without prior
| 7
Pipe Cover Installation Manual
12. The upper radius of the front panel must be fi tted behind
the water heater’s cover for proper installation (Fig.
8, pos.1). If necessary adjust the side panels to allow
the front cover to fi t properly. Once top of front panel
is fi tted behind the water heater’s cover, swing bottom
of front panel inwards (Fig.8, pos. 2). Ensure that the 4
screw holes line up with the threaded inserts on the side
panels. Secure using four machine screws.
Pipe Cover
side panel
Wall
1
2
Water
Heater
side
Pipe Cover
front panel
Water
Heater
cover
Fig. 8 Front panel installation
13. When fi tting properly, tighten the attachment screws
at the bottom of the water heater to hand tight. Then
install and tighten screws for the front panel of the pipe
cover. This installation is now complete (See Fig. 9).
14. On outdoor installations, install the outdoor vent
conversion cap in accordance with the installation
instructions included in the outdoor kit packaging.
Fig. 9 Completed pipe cover installation
To Next Page
Loading...
