Bosch GWS18V-8 - Battery Pack Installation

-11-
Model number GWS18V-8
Battery 18V (Bosch Series)
Rated speed n 11,000/min
Switch Type Side
Spindle thread 5/8"-11 UNC
Max. spindle length 9/16" (14,3 mm)
Max.Type 27 grinding wheel ⌀ 4 1/2" (115mm)
Type 27 grinding wheel thickness 1/8" - 1/4" (3mm - 6mm)
Max.Type 41/1A, 27A cutting wheel ⌀ 4 1/2" (115mm)
Max. flap disc ⌀ 4 1/2" (115mm)
Max. sanding disc ⌀ 4 1/2" (115mm)
Max. wire wheel ⌀ 4" (102mm)
Max. wire cup brush ⌀ 3" (76 mm)
Functional Description and Specifications
Disconnect battery pack from tool before making any assembly,
adjustments or changing accessories. Such preventive safety measures
reduce the risk of starting the tool accidentally.
Inserting and Releasing
Battery Pack
This tool is equipped with Automatic
Restart Protection. This feature helps
prevent accidental startups after power has
been interrupted, e.g. the battery was
removed with the switch locked in the on
position. To resume operation, turn the side
switch to the off position, and back to on
position to restart the tool.
Make sure that the side switch (Fig. 1) is in
the off position before inserting or removing
battery pack. To insert the battery pack
slide it into the housing until the battery
pack locks into position.
Your tool is equipped with a secondary
locking latch to prevent the battery pack
from completely falling out of the handle,
should it become loose due to vibration.
To remove the battery pack, press the
battery pack release button and slide the
battery pack forward.
Press the battery pack release button again
and slide the battery pack completely out of
tool housing (Fig. 2).
Fig. 2
Assembly
Disconnect battery pack from tool before making any assembly,
adjustments or changing accessories. Such preventive safety measures
reduce the risk of starting the tool accidentally.
2610067310_04-21_GWS18V-8.qxp_GWS 4/1/21 10:06 AM Page 11