-24-
NOTE: Not recommended for use with type 11 cup wheels.
Maintenance
To avoid accidents, always disconnect the tool and/or charger from the
power supply before servicing or cleaning.
Accessories and Attachments
Standard equipment Optional accessories and attachments
- Type 27 wheel guard
- Lock nut
- Backing flange
- Side handle
- Lock nut wrench
- Type 41/1A wheel guard
- Hand guard
The use of any other attachments or acces so ries not specified in
this manual may create a hazard.
Store accessories in a dry and temperate environment to avoid corrosion and
deterioration.
Service
NO USER SERVICEABLE
PARTS INSIDE.
Preventive maintenance performed by un -
au thorized personnel may result in
misplacing of internal wires and
components which could cause serious
hazard. We recom mend that all tool service
be performed by a Bosch Factory Service
Center or Authorized Bosch Service Station.
SERVICE MEN: Disconnect tool and/or
charger from power source before servicing.
Batteries
Be alert for battery packs that are nearing
their end of life. If you notice decreased
tool performance or significantly shorter
running time between charges then it is
time to replace the battery pack. Failure to
do so can cause the tool to operate
improperly or damage the charger.
Tool Lubrication
Your Bosch tool has been properly
lubricated and is ready for use.
D.C. Motors
The motor in your tool has been engineered
for many hours of dependable service. To
maintain peak efficiency of the motor, we
recommend it be examined every six
months. Only a genuine Bosch replacement
motor specially designed for your tool
should be used.
Cleaning
Certain cleaning agents
and solvents damage
plastic parts. Some of these are: gasoline,
car bon tetrachloride, chlorinated cleaning
solvents, ammonia and household
detergents that contain ammonia.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through opening.
2610067310_04-21_GWS18V-8.qxp_GWS 4/1/21 10:07 AM Page 24
To Next Page
Loading...
