en Cleaning function
22
.Cleaning function
Cl eani ng function
Use the "Pyrolytic self-cleaning" function to clean the
cooking compartment.
You can choose from three cleaning settings.
The dirtier the cooking compartment and the longer the
dirt has been there, the higher the cleaning setting
should be. It is sufficient to clean the cooking
compartment every two to three months. If required, you
can clean the oven more frequently. A cleaning cycle
requires only approx. 2.5 – 4.7 kilowatt hours.
Notes
■ For safety reasons, the appliance door locks
automatically once a certain temperature is reached.
It cannot be reopened until the n symbol for the
locking mechanism on the display goes out.
■ The interior lighting does not come on during the
cleaning function.
:Warning
Risk of burns!
■ The cooking compartment becomes extremely hot
during the cleaning function. Never open the
appliance door. Allow the appliance to cool down.
Keep children away from the appliance.
Risk of burns!
■ ; The appliance will become very hot on the
outside during the cleaning function. Never touch the
appliance door. Allow the appliance to cool down.
Keep children away from the appliance.
:Warning
Risk of harm to health!
The cleaning function heats up the cooking
compartment to a very high temperature so that food
remnants left over from roasting, grilling and baking will
burn off.This process releases vapours, which can
irritate the mucous membranes. While the cleaning
function is running, keep the kitchen well ventilated. Do
not remain in the room for long periods. Keep children
and pets away. Follow the instructions even when using
the Delayed start function with a delayed end time.
Prior to initiating the cleaning function
While cleaning is in progress, you can clean an
accessory at the same time, e.g. the universal pan or
the baking tray. Before cleaning is started, remove the
worst dirt. Slide the accessory in at level 2.
Clean the inside of the appliance door and along the
surface edges of the cooking compartment in the area
around the seal. Do not scrub the seal and do not
remove!
Note: When using the cleaning function, you can clean
the enamel accessory provided at the same time. You
cannot clean any of the wire racks when using the
cleaning function. The wire racks are not suitable for
cleaning using the cleaning function; this will discolour
them. Further accessories suitable for cleaning using
the cleaning function are listed in the table for special
accessories. ~ "Accessories" on page 11
:Warning
Risk of fire!
■ Loose food residues, grease and meat juices may
catch fire during the cleaning function. Before
starting the cleaning function, remove coarse dirt
from the cooking compartment and from the
accessories.
Risk of fire!
■ The appliance will become very hot on the outside
during the cleaning function. Never hang
combustible objects, e.g. tea towels, on the door
handle. Do not place anything against the front of
the appliance. Keep children away from the
appliance.
Risk of fire!
■ If the door seal is damaged, a large amount of heat
will be generated around the door. Do not scrub or
remove the seal. Never operate the appliance if the
seal is damaged or missing.
:Warning – Risk of serious damage to health!
The appliance will become very hot during the cleaning
function. The non-stick coating on baking trays and tins
is destroyed and noxious gases are released. Never
clean non-stick baking trays and baking tins using the
cleaning function. Only clean enamelled accessories
using the cleaning function.
Setting the cleaning function
Before setting the cleaning function, ensure that you
have followed all instructions for preparation.
The duration of each cleaning setting is preset and
cannot be changed.
1. Touch the v field.
The cleaning setting is highlighted in white in the
display.
2. Turn the rotary selector to set the cleaning setting.
3. Confirm using the l Start/Stop button.
A note appears relating to the preparations required
for the cleaning function.
4. Press the l Start/Stop button to start.
The duration counts down in the display. The heating
line does not appear for the cleaning function.
The cleaning function starts.
Ventilate the kitchen when the cleaning function is
running.
The appliance door locks shortly after the function starts
running. A message and the n symbol appear on the
display.
When the cleaning function has ended, an audible
signal sounds. The duration 00 m 00 s is shown in the
display. Press the ÿ On/Off button to switch off the
appliance.
The appliance door cannot be reopened until the n
symbol for the locking mechanism goes out.
Setting Cleaning level Duration
1 Light Approx. 1 hour, 15 minutes
2 Medium Approx. 1 hour, 30 minutes
3 Intensive Approx. 2 hours
To Next Page
Loading...
