58300000202443_ARA_EN_C JANUARY 2018 Service Manual for Bosch 800 Series Built-in Wall Ovens
Page 37 of 43
Copyright by BSH Home Appliances Corporation 1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614 800 944-2904
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
7.2.2 Setting the Option Code
Option codes are programmed into the control module and are used
to define cavity type and oven configuration. In the event it becomes
necessary to manually program an option code in Service mode, the
table below can be used as a reference.
3155
1. Follow the steps in the Accessing Service Mode section.
2. Advance through the menu until Option Code: #### is visible
(#### = current option code).
3. Press (1) to edit; option code will blink when editable.
4. Use the numeric keypad to enter the new option code.
5. Press Enter when the correct option code is displayed.
6. Press Oven Clear/Off on single ovens or Upper Clear/Off on
double ovens to exit Service Mode.
Always confirm that the oven and all components are functioning
normally after setting the option code.
7.2.3 Displaying Error Memory
1. Follow the steps in the Accessing Service Mode section.
2. Advance through the menu until Error Memory is visible
3. Press (1) to show the error list; if no errors are logged, nonE
will be visible in the display.
Errors are displayed in numeric order; the error code (Exxx)
will appear on the left and the error count will appear on the
To Next Page
Loading...
