5.2 Disable Factory Defaults 46
5.3 Configuring for email 47
6
System Operations 52
6.1 Arming the system in AWAY Mode 52
6.2 Disarming the system from AWAY Mode 52
6.3 Arming the System in STAY Mode 1 53
6.4 Disarming the system from STAY Mode 1 54
6.5 Arming the system from STAY Mode 2 54
6.6 Disarming the system from STAY Mode 2 55
6.7 Codepad duress alarm 56
6.8 Codepad panic alarm 56
6.9 Codepad fire alarm 56
6.10 Codepad medical alarm 56
6.11 Isolating zones 56
6.12 Standard isolating 57
6.13 Code to isolate 57
6.14 Fault analysis mode 58
6.15 Fault descriptions 59
7
System Functions 62
7.1 Installer Code Functions 62
7.1.1 Add or Delete RF Wireless Devices 62
7.1.2 Set the Number of Days until the First Test Report 63
7.1.3 Change Domestic Phone Numbers 64
7.1.4 Change Telco Arm/Disarm Sequence 65
7.1.5 Setting STAY Mode 2 Bypass Zones 66
7.1.6 Turning Report Monitor Mode On and Off 67
7.1.7 Walk Test Mode 68
7.1.8 Event Memory Recall Mode 68
7.2 Master Code Functions 69
7.2.1 Arm or Disarm both Areas at the Same Time 69
7.2.2 Changing and Deleting User Codes 70
7.2.3 Changing and Deleting Remote Radio User Codes 70
7.2.4 Deleting User/Radio Codes 71
7.2.5 Change Domestic Phone Numbers 71
7.2.6 Change Telco Arm/Disarm Sequence 73
7.2.7 Setting STAY Mode 2 Bypass Zones 74
7.2.8 Turning Outputs On and Off 75
7.2.9 Setting the Date and Time 75
7.2.10 Walk Test Mode 76
7.2.11 Event Non-Volatile Memory Recall Mode 76
7.3 User Code Functions 77
7.4 Hold-Down Functions 77
7.4.1 Arm the System in AWAY Mode 77
7.4.2 Arm the System in STAY Mode 1 78
7.4.3 Arm the System in STAY Mode 2 78
7.4.4 Horn Speaker Test 78
7.4.5 Bell Test 78
7.4.6 Strobe Test 78
7.4.7 Turning Day Alarm On and Off 78
4 en | Table of Contents Control Panel
2014.07 | 00n | F01U298026 Installation Guide
To Next Page
Loading...
Need help?
General
