7.4.8 Fault Analysis Mode 79
7.4.9 Initiate a Modem Call 79
7.4.10 Reset Latching Outputs 79
7.4.11 Change the Codepad Buzzer Tone 79
7.4.12 Send Test Report 80
8
Domestic Dialing 81
8.1 Domestic Dialing Funtion 81
8.2 Setting Up and Programming Domestic Reporting 81
9
Zone Information 83
9.1 Day Alarm Information 83
9.1.1 Day Alarm Resetting 83
9.1.2 Day Alarm Latching 83
9.1.3 Day Alarm Operation 83
9.2 EOL Resistor Value 84
9.3 Zone Programming 85
9.3.1 Zone Defaults 86
9.3.2 Zone Types 90
9.3.3 Zone Pulse Count 92
9.3.4 Zone Pulse Count Time 92
9.3.5 Zone Options 1 93
9.3.6 Zone Options 2 94
9.3.7 Zone Report Options 95
9.3.8 Keyswitch Zone Options 95
9.4 Swinger Shutdown Count for Siren 97
9.5 Swinger Shutdown Count for Report 97
9.6 System Status Programming 98
9.6.1 System Status Reporting Options 98
9.6.2 Test Reporting Time 98
9.6.3 Test Reporting Options 99
9.7 STAY Mode 2 Automatically Bypass Zones 99
10
System Event Timers 101
10.1 Programming Entry/Exit Timers 101
10.2 Entry Timer 1 101
10.3 Entry Timer 2 101
10.4 Exit Timer 101
10.5 Entry Guard Timer for STAY Mode 102
10.6 Delay Alarm Reporting Time 102
10.7 Sensor Watch Time 102
10.8 Codepad Lockout Time 103
10.9 Siren Run Time 103
10.10 Siren Sound Rate 103
10.11 Auto Arming Pre-Alert Timer 103
10.12 Auto Arming Time 104
10.13 Auto Disarming Time 104
10.14 Kiss-Off Wait Time 105
10.15 Speaker Beep Volume 105
11
System and Consumer Options 106
11.1 System Options 1 106
11.2 System Options 2 106
Control Panel Table of Contents | en 5
Installation Guide 2014.07 | 00n | F01U298026
To Next Page
Loading...
Need help?
General
