Need help?Do you have a question about the Bosch ICP-CC488 and is the answer not in the manual?
General| No of Points | 8 |
|---|---|
| No of onboard zones | 8 |
| Partitions | 2 |
| Keypads | Up to 4 |
| Onboard Communicator | Yes |
| Operating Temperature | -10°C to +55°C |
| Storage Temperature | -20°C to +60°C |
| Enclosure Protection | IP30 |
| Expandable zones | Up to 16 |
| Communication formats | CID, SIA |
| Power Supply | 16.5VAC, 40VA |
| Current Consumption | 90mA (panel only) |
| Communication Interface | RS-232 |
| Compatible Protocols | Bosch |
Describes the indicators for each zone on the codepad.
Explains the AWAY indicator's function when the system is armed.
Explains the STAY indicator's function when the system is armed.
Indicates when the system is in a disarmed state.
Shows the status of the AC MAINS power supply.
Indicates the system is disarmed or a zone is sealed.
Detailed descriptions of various system faults.
Allows description of zones and programming for isolation or day alarm.
Fields to assign names to user codes and identify the Master Code.
Fields to configure entry and exit delay times for the system.
Settings for single button arming, forced arming, and remote arming.
Fields to describe the function of system outputs.
Choices for standard isolation or code-to-isolate methods.
Settings for back to base and domestic reporting.
System information like siren run time and technician servicing.
Space to record RF radio keyfob ID numbers for user codes.
Space to record RF device ID numbers for each zone.
To Next Page
