ICP-CC488 | User's Guide | 6. Radio Transmitter Operations EN | 10
Bosch Security Systems, Inc. | 12/08 | F01U089456-02
3. Enter the nine digit ID number found on the
back of the radio remote hand held transmitter,
followed by the [#] button. Two beeps are heard
and the STAY and AWAY indicators extinguish.
To add or change other radio remote user codes,
repeat this procedure as many times as required.
5.3 Deleting User/Radio Codes
Only the Master Code holder can delete other
system user codes.
How to Delete a User Code
1. Enter your four character Master Code, followed
by [1] and the [#] button (for example,
[25801#]).
Three beeps sound and the STAY and AWAY
indicators flash.
2. Enter the user code number (1 to 16), followed
by the [#] button (for example, [2#] = User 2,
[16#] = User 16). Two beeps sound and the
selected user number displays on the codepad
indicators.
3. Press the [*] button to delete the selected User
Code.
Two beeps are heard and the STAY and AWAY
indicators turn off. To delete other User Codes,
repeat this procedure as many times as required.
6. Radio Transmitter
Operations
Figure 5: RF3332: 2-Button Keyfob
Transmitter
1
2
3
1 – Arm button
2 – Disarm button
3 – Arm and Disarm buttons: Press both buttons
at same time for 2 sec to send a Panic alarm.
Figure 6: RF3334: 4-Button Keyfob
Transmitter
5
4
1
2
3
1 – Arm button
2 – Disarm button
3 – Option 1 button
4 – Option 2 button
5 – Arm and Disarm buttons: Press both buttons
at same time for 2 sec to send a Panic alarm
To Next Page
Loading...
