Why is my Bosch Lawn Mower perimeter wire constantly being cut?
Your Bosch Lawn Mower perimeter wire might be constantly cut because the wire is not taut between the pegs. Make the wire taut and ensure the distance between pegs is a maximum of 75cm. Another reason may be that the distance between pegs is more than 75cm. Use wire connectors to repair any breaks and avoid using a verticutter or scarifier over the perimeter wire.
What should I do if I cannot perform the charging procedure on my Bosch INDEGO 400?
If you cannot perform the charging procedure on your Bosch Lawn Mower, clean the charging pins.
What to do if the perimeter wire is not detected on my Bosch INDEGO 400 Lawn Mower?
If the perimeter wire is not detected on your Bosch Lawn Mower, re-strip the wire for a proper connection, as the wire terminal may have corroded.
What to do if the wire is crossed when marking an object for my Bosch INDEGO 400?
Check that the wire is laid around the object in a clockwise direction.
Why is my Bosch Lawn Mower not operating?
Your Bosch Lawn Mower might fail to operate due to several reasons. First, ensure the isolator switch is turned on. Remove the mower from the dock, turn on the switch, and replace it in the dock, ensuring the dock is on with a solid green LED. Press the confirm button and enter your 4-digit PIN. Also, check for clogging, turning the isolator switch off first and wearing protective gloves while clearing any debris. Other potential causes include a battery that is not fully charged (replace the mower in the docking station), grass that is too long (mow to at least 40mm and increase the height of cut), or a battery that is too hot or cold (allow the mower to cool/warm or move the dock to a shaded area, as the mower operates between 5°C – 45°C). Interference with the perimeter wire can also be...
General safety warnings and instructions for operating the Indego robotic mower.
General| Type | Robotic lawn mower |
|---|---|
| Cutting width | 190 mm |
| Grass catcher | - |
| Product color | Black, Green |
| Cutting system | Rotary blades |
| Built-in display | Yes |
| Number of blades | 3 |
| Maximum lawn area | 400 m² |
| Recommended lawn area | 20 m² |
| Maximum cutting height | 50 mm |
| Minimum cutting height | 30 mm |
| Grass collecting volume | - L |
| Suitable for slope up to | 27 % |
| International Protection (IP) code | IPX4 |
| Power source | Battery |
| Charging time | 0.75 h |
| Battery voltage | 18 V |
| Battery capacity | 2.5 Ah |
Weight and Dimensions| Weight | 7500 g |
|---|
To Next Page
