With enough required space and in the correct orientation.
The docking station for your Indego needs to be placed at the side of your lawn, in a corner or on the edge.
It is important that you leave enough space around the docking station, as indicated in the image below, and that the
docking station is facing in the correct direction. Failure to do so will prevent your Indego from docking correctly.
The house symbol should face towar
ds the areas outside of the perimeter wire, whilst the tree symbol should
point towards the cutting area.
Your Indego moves in a clockwise direction to the docking station. Any other positioning will prevent your mower from
docking correctly.
Feed the perimeter wire
through the cable duct underneath the
docking station as indicated by the arrow
until it appears on the other side.
The docking station is an important reference point for your Indego. Any deviation from the installation as shown in
the pictures may result in issues with the navigation/performance of your Indego and should therefore be avoided.
Carefully strip
10–15 mm of insulation off the wire.
3.4
3.5
3.6
3.8
3.7
Edge of the lawn placement
Fix the 4 docking station
screws in place with the hex key.
Connect the wire
to the black connector point.
Ensure that no stripped wire is
visible outside of the connector
points.
GB
Corner placement
30 cm
150 cm
100 cm
> 100 cm
30 cm
!
150 cm
> 100 cm
30 cm
3534
To Next Page
Loading...
