Bosch KGN392LBF - Device Shutdown and Cleaning; Shutdown and Decommissioning; Cleaning Precautions and Procedures; Component Removal for Cleaning

NL
The cleaning water must not enter
the following areas:
Switch off device
and out of action
set
■ Controls
■ Relief
■ Vents
■ Openings in the separator plate
Switching off the device
Pull out the mains plug or unscrew or
disconnect the fuse.
Switch off.
Proceed as follows:
1. Pull out the mains plug or switch off
the fuse.
Chiller shuts down.
2. Remove frozen food and store
in a cool place.
Place the cold accumulator (if present)
on the food.
Decommissioning the
device
If you do not use the device for a long
time:
3. The flushing water must not enter
the controls, lighting, ventilation
openings or the openings of the
separator plate!
1. Pull out the mains plug or switch off
the fuse.
2. Clean the device.
3. Leave the appliance doors open.
Clean the appliance with a soft cloth
and lukewarm water with a dash of
pH neutral detergent.
4. Only clean the door seal with clean
water and wipe it dry thoroughly.
Cleaning of
the device
5. After cleaning, reconnect the device.
mAttention
6. Put frozen food back in the
freezer compartment.
■ Do not use cleaning agents or
solvents containing sand, chloride or
acids.
Performance
■ Do not use abrasive or
scratching sponges.
All variable parts of the device can be
removed for cleaning.
Corrosion can develop on the
metal surfaces.
Remove shelves from the door
Fig. †
■ The shelves and storage
compartments must not be cleaned
in the dishwasher.
Lift and remove shelves.
Remove glass shelves
Pull the glass shelves forward and
They can distort!
remove.
82