Why aren't individual cameras responding to alarms on my Bosch LTC 8600 Controller?
If individual cameras/monitors are not responding when alarmed on your Bosch Controller, ensure the desired cameras are properly armed on the appropriate armed monitors in the system. Verify the alarming device and cable to the Alarm Interface unit are intact.
How to correct an incorrect alarm response on Bosch LTC 8600?
If experiencing an incorrect system alarm response on your Bosch Controller, verify that the desired alarm response mode has been selected.
What to do if there are no keyboard display indicators on Bosch LTC 8600 Controller?
If you have no keyboard display indicators on your Bosch Controller, check the interconnect cable for cut or broken wires between the keyboard and the main CPU bay. Replace the cable if necessary. Relocate the keyboard connector on the main CPU bay to another keyboard input port. Replace the keyboard.
How to fix a non-operative receiver/driver on Bosch LTC 8600?
If an individual receiver/driver is non-operative on your Bosch Controller, check the green LED indicator on the fuse bracket in the receiver/driver box. This signifies that AC power is applied by the keyboard. If not, check the shielded-twisted-pair cable between the Signal Distribution Unit and the receiver/driver box. Confirm the camera address setting in the receiver/driver corresponds to the same camera number as selected by the keyboard. Perform an internal receiver/driver local test to verify the operation of the receiver/driver circuitry and pan/tilt/zoom wiring.
What to do if Bosch LTC 8600 lights red due to low battery?
If the lights are red, indicating a low or dead CPU battery condition on your Bosch Controller, replace the batteries, per the procedure described in the Maintenance Information section.
General| Brand | Bosch |
|---|---|
| Model | LTC 8600 |
| Category | Controller |
| Language | English |
To Next Page