Bosch MIC-7502-Z30W - Ethernet Connections; Camera Connections

28 en | Connections MIC IP starlight 7000i
2017.09 | 0.12 | F.01U.xxx.xxx Installation Manual Bosch Security Systems
!
Caution!
Compliance with EN50130-4 Alarm Standard – CCTV for Security Applications
To meet the requirements of the EN50130-4 Alarm Standard, an ancillary uninterruptable
power (UPS) supply is necessary. The UPS must have a Transfer Time between 2–6 ms and a
Backup Runtime of greater than 5 seconds for the power level as specified on the product
datasheet.
8.3 Ethernet Connections
!
Caution!
Ethernet cables must be routed through earth-grounded conduit capable of withstanding the
outdoor environment.
Cable Type Cat5e/Cat6e Ethernet (Shielded Twisted Pair (STP)) (directly to the
camera, or to a network switch between the camera and the network)
Note: Cat5e/Cat6e Shielded Twisted Pair (STP) cable is required in
order to meet European regulatory EMC standards.
Maximum Distance 100 m (330 ft)
Ethernet 10BASE-T/100BASE-TX, auto-sensing, half/full duplex
Terminal Connector RJ45, Male
High PoE For models with attached illuminators: Use the 95 W midspan sold by
Bosch.
For models without illuminators: Use the 60 W midspan sold by Bosch,
or a midspan that is compliant to the IEEE 802.3at, class 4 standard.
Note: Consult the National Electrical Code (NEC) or other regional standards for cable
bundling requirements and limitations.
8.4 Camera Connections
All electrical and data connections from the camera are made from the connectors in the base
of the camera.
Figure8.1: MIC7000 connectors