J
Jennifer HenryAug 14, 2025
How to fix a Bosch Control Unit when the light is constantly red?
- SSean BarronAug 14, 2025
If your Bosch Control Unit light is constantly red, this indicates an internal fault. To resolve this, replace the module.
To Next PageTo Next PageHow to fix a Bosch Control Unit when the light is constantly red?
If your Bosch Control Unit light is constantly red, this indicates an internal fault. To resolve this, replace the module.
What to do if Bosch MM100 is constantly OFF?
If your Bosch Control Unit is constantly off, there might be several reasons. First, ensure the coding card is properly set. Then, check if the power supply has been interrupted and switch it on. Also, a defective fuse could be the cause, so replace it after switching off the power supply. Finally, inspect the BUS connection for a short circuit and repair if necessary.
Why is the green light flashing on my Bosch Control Unit?
If the green light is flashing on your Bosch Control Unit, it could be due to exceeding the maximum cable length for the BUS connection. Try making the BUS connection shorter. Alternatively, a fault might be shown on the user interface display; consult the user interface instructions and the service manual for troubleshooting.
What to do if Bosch MM100 Control Unit is flashing red?
If your Bosch Control Unit is flashing red, it might be due to the coding card being in an invalid or intermediate position; ensure the coding card is properly set. Another potential cause is that the temperature limiter on MC1 (15-16) is not connected; connect the jumper (supplied) or a temperature limiter to MC1.
How to fix a constantly red Bosch MM100?
If your Bosch Control Unit is constantly red, this indicates an internal fault. The suggested solution is to replace the module.
What to do if my Bosch Control Unit is constantly off?
If your Bosch Control Unit is constantly off, there might be several reasons. First, check if the code switch is set correctly. If it isn't, set the code switch. Second, make sure the power supply is properly connected and switched on. Third, verify the fuse isn't broken; if it is, replace it after switching off the power supply. Finally, inspect the BUS connection for any short circuits and repair if necessary.
Why is my Bosch Control Unit flashing red?
If your Bosch Control Unit is flashing red, it could be due to a couple of reasons. One potential cause is that the code switch is in an invalid or intermediate position; in this case, set the code switch correctly. Another reason might be that the temperature limiter on MC1 (15-16) is not connected; connect the provided jumper or temperature limiter to MC1.
What to do if my Bosch Control Unit is flashing green?
If your Bosch Control Unit is flashing green, it could be due to the BUS connection being too long; shorten the BUS connection. Another possible reason is a fault shown on the user interface display. Refer to the user interface instructions and the service manual for further troubleshooting information.
What does it mean when my Bosch Control Unit is constantly green?
Standard operation.
General| Brand | Bosch |
|---|---|
| Model | MM100 |
| Category | Control Unit |
| Language | English |
