What to do if my Bosch Controller is constantly OFF?
If your Bosch Controller is constantly OFF, it could be due to a few reasons. First, ensure that the mains power supply is turned on. If the power supply is active, check the fuse and replace it if it's faulty, but only after switching off the power supply. Finally, a short-circuit in the BUS connection could be the problem; inspect the BUS connection and repair it if needed.
Why is my Bosch Controller flashing green?
A flashing green light on your Bosch Controller can indicate that the maximum cable length of the BUS connection has been exceeded. Try shortening the BUS connection. Alternatively, this could indicate a fault display on the control unit display. Consult the instructions for the control unit and the service manual for troubleshooting.
What to do if my Bosch Controller is constantly red?
If your Bosch Controller displays a constant red light, this indicates an internal fault. The suggested solution is to replace the module.
Explains signal words like DANGER, WARNING, CAUTION, NOTICE for risk indication.
Provides safety rules for target group, intended use, installation, and handover procedures.
Lists items included in the delivery package.
Provides technical specifications like dimensions, voltage, power, and temperature ranges.
General steps for mounting the module on a wall or mounting rail.
Covers BUS connection, sensor, power supply, pump, mixer, and diagrams.
General| Category | Control Unit |
|---|---|
| Manufacturer | Bosch |
| Model | MP 100 |
| Input voltage | 24 VDC |
| Operating temperature | -20°C to +60°C |
To Next Page
