76 en | Day and night mode Panel Controller
F.01U.076.969 | 6.0 | 2010.04 Operation guide Bosch Sicherheitssysteme GmbH
17 Day and night mode
This chapter contains information about the following points:
– Switching between day and night mode
– Changing the time for resetting to night mode
The manner in which an incoming alarm is handled depends on whether the system is in day
or night mode; see Section 9 Fire alarm, page 44.
The following symbols on the status bar or standby display show which mode the panel is
switched to. In the case of networked panels, "Day Mode" is displayed until all networked
panels have been switched to night mode. While one panel is still in day mode, the day mode
icon is also displayed on all other panels.
17.1 Switching between day and night mode
There are two ways to switch between day and night mode:
– Switching over via the menu
– Switching via the status bar
CAUTION!
Night mode is the highest security level as every incoming alarm is forwarded to external
stations.
NOTICE!
Depending on the security level in question, not all detectors can be switched to day mode.
Night mode
Day mode
NOTICE!
Please note that following a transmission fault it may be necessary to synchronize the day/
night mode of the other panels manually in order for the current mode to be displayed
correctly.
NOTICE!
Depending on the programming, the panel automatically switches from day to night mode at
the preset time.
It is only possible to switch to day mode manually.
To Next Page
Loading...
