24 | English
1 609 92A 1XZ | (5.9.16) Bosch Power Tools
Assembly
Inserting/Replacing the Batteries (see figure A)
Using alkali-manganese or rechargeable batteries is recommended for
operation of the measuring tool.
To open the battery lid 15, press the latch 14 and remove the battery lid.
Insert the batteries/rechargeable batteries. When inserting, pay attention
to the correct polarity according to the representation on the inside of the
battery compartment.
When the battery low indicator b is indicated the first time in the display,
measurements can be made for only about 1–2hours.
When the battery low indicator b flashes, the batteries/rechargeable
batteries must be replaced. Measurements are no longer possible.
Always replace all batteries/rechargeable batteries at the same time. Do
not use different brands or types of batteries/rechargeable batteries
together.
Remove the batteries/rechargeable batteries from the measuring
tool when not using it for longer periods. When storing for longer
periods, the batteries/rechargeable batteries can corrode and self-
discharge.
Mounting the Leg Extension
Slide the leg extension 2 onto the front of the fold-out leg 1. Slide the leg
extension as far as necessary over the joint of the measuring tool.
Storage temperature
– 20 °C ... +70 °C
Batteries
2x1.5 V LR6 (AA)
Operating time, approx.
25 h
Automatic switch-off after approx.
5min
Leg length
400 mm
Weight according to EPTA-Procedure 01:2014
0.89 kg
Dimensions
425 x 41 x 58 mm
Digital Angle Measuring Device PAM 220
The measuring tool can be clearly identified with the serial number 13 on the type plate.
OBJ_BUCH-2116-003.book Page 24 Monday, September 5, 2016 5:52 PM
To Next Page
Loading...
