English | 27
Bosch Power Tools 1 609 92A 1XZ | (5.9.16)
If you press the “180°” button, the angle v (supplementary angle) you are
looking for will be calculated and displayed.
Measuring “Simple Mitres”
“Simple mitre” measurement is used to calculate the cutting angle “MTR”
when two workpieces with the same mitre have to form an outer angle x°
smaller than 180° (e.g. for skirting boards, banister columns or picture
frames).
When workpieces are to be fitted into a corner (e.g. for floor trimmings),
measure the corner angle x° by applying the fold-out leg and the base leg.
For given angles (e.g. picture frames), open the fold-out leg and the base
leg until the desired angle is indicated in the display.
w
v
x
°
OBJ_BUCH-2116-003.book Page 27 Monday, September 5, 2016 5:52 PM
To Next Page
Loading...
