English | 29
Bosch Power Tools 1 609 92A 1XZ | (5.9.16)
Press the “MTR” button 8. As long as you hold down the “MTR” button 8,
the calculated horizontal mitre angle “MTR”, which has to be set on the mi-
tre saw, will be displayed. At the same time, the “MTR” indicator will light
up in the display.
Note: The calculated mitre angle “MTR” can only be taken over for chop and
mitre saws, for which the setting for vertical cuts is 0°. When the setting for
vertical cuts is 90°, the angle for the saw must be calculated as follows:
90° – indicated “MTR” angle = angle to be set on the saw.
Measuring “Compound Mitres”
“Compound mitre” measurement (“Compound MTR”) is used to calculate
horizontal and vertical mitre angles when two workpieces with multiple an-
gles (e.g. crown mouldings) have to join precisely.
First measure the spring angle (SPR) and the corner angle (CNR). The meas-
uring tool will then calculate the mitre angle (MTR) and the bevel angle (BVL).
Carry out the worksteps exactly in the given sequence.
MTR
SPR
CNR
OBJ_BUCH-2116-003.book Page 29 Monday, September 5, 2016 5:52 PM
To Next Page
Loading...
