14 | English
1 609 929 W25 | (25.1.10) Bosch Power Tools
Technical Data
Assembly
f Avoid unintentional starting of the ma-
chine. During assembly and for all work on
the machine, the power plug must not be
connected to the mains supply.
Delivery Scope
Before starting the operation of the machine for
the first time, check if all parts listed below have
been supplied:
– Chop and mitre saw with mounted saw blade
– Dust bag 24
– Locking knob 12
– Extension bar 7 (2x)
– Material clamp 6
– Ring spanner 17
Note: Check the power tool for possible dam-
age.
Before further use of the machine, check that all
protective devices are fully functional. Any light-
ly damaged parts must be carefully checked to
ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Additionally required tools (not in delivery
scope):
– Phillips screwdriver
– Angle gauge
– Open-end spanner (13 mm)
– Allen key (6 mm)
Chop and Mitre Saw PCM 1800
Article number
3 603 L01 040
Rated power input
W 1800
Rated voltage
V 240
Frequency
Hz 50
No-load speed
min
-1
4500
Cutting capacity,
max.
mm 70
Laser type
650 nm, < 1 mW
Laser class
2
Weight according to
EPTA-Procedure
01/2003
kg 13.8
Protection class
/II
Permissible workpiece dimensions (maximal/minimal)
see page 18.
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Dimension of suitable saw blades
Saw blade diameter
mm 254
Blade thickness
mm 1.5–2.8
Mounting hole diameter
mm 25.4
OBJ_BUCH-1142-001.book Page 14 Monday, January 25, 2010 8:52 AM
To Next Page
Loading...
